and much more.....

1. For tough jobs use full strength. Apply a small amount of BEAN-e-doo. Work in with a Scrub Pad. Always wipe surface or rinse with water when cleaning is complete.

2. For general cleaning on hard surfaces mix 50/50 with hot or cold water. Mix in bucket stirring occasionally. Apply and wipe clean with a wet cloth.

3. For metal, engine parts, machinery, shop tools, garden tools, etc, use full strength. Apply a small amount on metal parts to reduce vulnerability to rust.

4. Not recommended for use on wood or varnished surfaces, upholstery, aluminum or glass. May dull plastic. Do not mix with bleach or ammonia.

d-Grease

1. Apply to a wet screen from both sides and work in with a Scrub Pad. Continue to scrub until foam develops.

2. Wait 2-3 minutes.

3. Rinse the screen thoroughly from both sides, including the inside edge of the frame and frame corners with hot or cold water.

4. For stencil removal: After ink removal, wet both sides of the screen with warm water and apply product to both sides with pad or brush. Rinse with hot water. Then proceed to stencil removal.

1. Remove excess ink from screen and spray a small amount on both sides of screen (the less the better).

2. Work in with a devoted Scrub Pad.

3. Wipe clean both sides with a damp cloth.

4. Use dry cloth to wipe dry. Screen is now ready to re- ink and/or tape-off new areas.

If tape doesn't stick wipe again with DAMP cloth and dry. GREENEWAY is designed to be removed with a damp cloth.

1. Start with a relatively dry screen. Place flat side of screen down on a non-porous surface.

2. Spray a small amount of d-HAZE on the area to be cleaned.

3. Using a devoted Scrub Pad, work in well. Let sit for 1-2 minutes.

4. Use a lint free towel and wipe both sides until clean.

Reapply d-HAZE and repeat if necessary.

5. d-HAZE degreases as it cleans. Just spray with water and rinse clean. No need to use a separate degreaser. Water is necessary to activate this degreasing agent.

WARNING: d-HAZE will attack glue and cause mesh to release from screen, use with caution.

Fleece & adhesives
1. Spray on, wait 2-3 seconds.
2. Wipe clean.

Decals & Vinyl letters
1. Remove graphics with heat.
2. Spray on, wait 20-30 seconds.
3. Wipe clean and repeat if necessary.

Tar & Gum
1. Spray on, work in.
2. Wait 1-2 minutes.
3. Pick or wipe off.

Permanent marker or graffiti, grease or oil
1. Spray on.
2. Wipe clean.

1. Remove ink completely with Inkee-doo II or Greeneway.
2. Rinse thoroughly to remove solvent residues.
3. Shake well and apply Strip-e-doo to both sides. Work in with a Scrub Pad.
4. Wait 2 or 3 minutes. DO NOT ALLOW STRIP-E-DOO TO DRY.
5. Spray clean !

Strip-e-doo is a strong oxidant. Keep away from cleaning solvents. Always rinse solvent residues before applying.

Strip-e-doo can cause skin irritation, use gloves.

Eyes; Flush with water for 15 minutes.

Swallowed; Drink 2-3 glasses milk. Call physician.

Wash-Away

1. Remove excess ink form screen

2. Spray a small amount of Wash-Away on both sides of screen.

4. Wipe clean with a wet cloth or rinse both sides with water.